peak signal power in Vietnamese

@Chuyên ngành kỹ thuật
@Lĩnh vực: điện tử & viễn thông
-công suất đỉnh của tín hiệu

Sentence patterns related to "peak signal power"

1. Peak power = (peak potential in volts) × (peak beam current in amperes).

2. ‧Peak power‧ = (peak potential in volts) × (peak beam current in amperes).

3. Peak power» = (peak potential in volts) × (peak beam current in amperes).

4. “Peak power” = (peak potential in volts) × (peak beam current in amperes).

5. ‘Peak power’ = (peak potential in volts) × (peak beam current in amperes).

6. "Peak power" = (peak potential in volts) × (peak beam current in amperes).

7. 'Peak power' = (peak potential in volts) × (peak beam current in amperes).

8. 'Peak power' = (peak potential in volts) x (peak beam current in amperes).

9. ‘Peak power’ = (peak potential in volts) x (peak beam current in amperes).

10. [Peak power = (peak potential in volts) x (peak beam current in amperes).]

11. Peak power = (peak potential in volts) x (peak beam current in amperes).

12. Peak Amplitude is the difference between the mid-point of the signal and the positive peak

13. This thesis mainly discusses the multi-carrier phase code (MCPC) pulses signal, and the design of pulses trains with low peak-mean envelop power ratio (PMEPR).

14. Peak pulsed ‧power density‧ exceeding 500 W/cm2; or

15. The antenna is substantially aligned when the signal strength reaches a peak level.

16. The LGBT Bullyboys are at the peak of their power

17. The controller (21) receives AC power and provides a power signal on the power bus.

18. At the peak of its power, that aggressive nation seems unbeatable.

Vào lúc hùng mạnh tột độ, nước hay gây hấn này dường như vô song.

19. Device and method for adapting the power of an electric power supply system to actual peak loads

20. A digital power amplifier (DPA) generates a radio frequency (RF) signal based on the upconverted signal.

21. A calibration feedback signal is generated to adjust a driving signal of the wireless power transmitter based on the received signal.

22. Power savings by limiting use of advanced signal processing

23. The transmitter may receive the control signal and adjust a power of the RF input signal based on the control signal.

24. Therefore, power on an adjacent channel signal is accurately measured upon reception of a measurement signal.

25. A small filter Convolves only a part of a signal peak and therefore cannot detect a whole fluctuation within the signal, while a large filter Convolves 2 to 3 signal peaks at …