peak-to-peak valley value in Vietnamese
@Chuyên ngành kỹ thuật
@Lĩnh vực: điện lạnh
-giá trị đỉnh-đỉnh
Sentence patterns related to "peak-to-peak valley value"
1. Peak power = (peak potential in volts) × (peak beam current in amperes).
2. ‧Peak power‧ = (peak potential in volts) × (peak beam current in amperes).
3. Peak power» = (peak potential in volts) × (peak beam current in amperes).
4. “Peak power” = (peak potential in volts) × (peak beam current in amperes).
5. 'Peak power' = (peak potential in volts) x (peak beam current in amperes).
6. ‘Peak power’ = (peak potential in volts) x (peak beam current in amperes).
7. ‘Peak power’ = (peak potential in volts) × (peak beam current in amperes).
8. "Peak power" = (peak potential in volts) × (peak beam current in amperes).
9. 'Peak power' = (peak potential in volts) × (peak beam current in amperes).
10. Maximum attenuating speed D of side lobe peak value.
11. [Peak power = (peak potential in volts) x (peak beam current in amperes).]
12. Peak power = (peak potential in volts) x (peak beam current in amperes).
13. 8. microprocessors to calculate the cardinal points (beginning of peak, end of peak and top of peak);
14. That the surface's radiation cooling affects on the ground layer temperature inversion is presented as the relatively strong echo peak value corresponding to the temperature variety's valley value.
15. 24 The variation of the peak peak value with the depth of rectangular slot was affected by magnetization of ferromagnetic material.
16. Amole Peak rises on the western ridgeline of Wasson Peak, the highest peak in the area
17. Tasaday is also the name of the forested peak rising above their hidden valley.
18. Note: If the CMPA peak is sufficiently separated from other peaks valley-to-valley baseline allocation should be used, otherwise use dropping perpendiculars to a common baseline, which should have starting point close to the CMPA peak (thus not at t = 0 min!).
19. 17 A business cycle can be measured from peak to peak or from trough to trough.
20. Blackcap is a rugged peak closely linked with higher Monument Peak to the south
21. Peak to peak Amplitude is the difference between the positive and the negative peaks
22. An iron - spiked stick in hand he roamed at will , wandering from peak to peak .
23. The peak value (i = 272) is calculated assuming the following data of table C.
24. Dragontail Peak/Triple Couloirs
25. A compound containing two Bromines will have a [M + 2] peak twice the size of the [M +] peak and a [M + 4] peak the same size as the [M +] peak (Figure 6.6a)