peak-pulse level in Vietnamese

@Chuyên ngành kỹ thuật
@Lĩnh vực: điện tử & viễn thông
-mức của xung

Sentence patterns related to "peak-pulse level"

1. In Biphasic AEDs, the pulse is composed of a positive and negative peak

2. the peak level of single accelerating vehicle events.

3. an output energy exceeding 0,5 J per pulse and a "peak power" exceeding 50 W;

4. a. An output energy exceeding 1,5 J per pulse and a pulsed "peak power" exceeding 50 W; or

5. Gasoline prices are 14% below the peak level they hit in November.

6. Physiological parameters (finger pulse amplitude, skin conductance level, heart rate variability) were measured continuously.

7. The antenna is substantially aligned when the signal strength reaches a peak level.

8. Chirped pulse amplification (CPA) is a technique for amplifying an ultrashort laser pulse up to the petawatt level, with the laser pulse being stretched out temporally and spectrally, then amplified, and then compressed again.

9. Heat acclimatization lowered the level of the second peak , though it was remarkably prolonged.

10. Elevation ranges from sea level to 1,168 m (3,832 ft) on El Toldo Peak.

Độ cao dao động từ mực nước biển đến 1.168 m (3.832 ft) tại đỉnh El Toldo.

11. Chlordiazepoxide is slowly absorbed and may take several hours to reach a peak plasma level

12. Each half of the tri -level sync pulse is defined to be 44 samples (reference clock periods) wide, for a total sync pulse width of 88 samples.

13. 16 The spectrum level of microseismic noise tends to peak at about 1 / 6 Hz.

14. The highest peak in this range is about 10,000 feet [3,000 m] above sea level.

15. Kita-dake is Sakurajima's highest peak, rising to 1,117 m (3,665 ft) above sea level.

Kita-dake là đỉnh cao nhất của Sakurajima, cao 1.117 m (3.665 ft) so với mực nước biển.

16. The peak of the highest mountain in Pinghe County (Mount Daqin) is #,# metres above sea level

17. 17 The peak level is above normal, and fasting levels may or may not be elevated.

18. In music and music theory, the Beat is the basic unit of time, the pulse (regularly repeating event), of the mensural level (or Beat level).

19. Peak power = (peak potential in volts) × (peak beam current in amperes).

20. ‧Peak power‧ = (peak potential in volts) × (peak beam current in amperes).

21. Peak power» = (peak potential in volts) × (peak beam current in amperes).

22. “Peak power” = (peak potential in volts) × (peak beam current in amperes).

23. 'Peak power' = (peak potential in volts) x (peak beam current in amperes).

24. ‘Peak power’ = (peak potential in volts) x (peak beam current in amperes).

25. ‘Peak power’ = (peak potential in volts) × (peak beam current in amperes).