1. it costs 12 per metre.

2. It is expressed in amperes per metre (A/m).

3. It is expressed in amperes per metre (A/m

4. It is expressed in ampere per metre (Am–1).

5. ‘At 50000 Becquerels per cubic metre, this level of Radon gas was 250 times the recommended safe limit of 200 Becquerels per cubic metre, he pointed out.’ ‘Thirty of them were found to be above the high radon ‘reference level’, which is 200 Becquerels per cubic metre of air.’

6. Moreover, typical passenger rail carries 2.83 times as many passengers per hour per metre width as a road.

7. 5403.32.00 00 - -Of viscose rayon, with a twist exceeding 120 turns per metre

8. The sport is contested in 100 metre, 500 metre, 700 metre, 1,000 metre, and 1,500 metre distances.

9. Buckram fusible iron on stiff fabric - extra wide 60" (152cm) wide - per metre

10. However, important advantages accrue if diver surveys measure absolute numbers or biomass per square metre.

11. radiant exposure, the time integral of the irradiance, expressed in joules per square metre [J m-#]

12. Trujillo, load up six unmarked cars, four men per car.

13. radiant exposure: the time integral of the irradiance, expressed in joules per square metre [J m-#]

14. 20 particles of dust per cubic metre. 52 ultraviolet radiation spikes and a class-two comet.

15. AMOUNTS SHALL BE EXPRESSED IN MICROGRAMMES PER CUBIC METRE OF AIR AT STANDARD TEMPERATURE AND PRESSURE .

16. radiant exposure, the time integral of the irradiance, expressed in joules per square metre [J m-2];

17. radiant exposure: the time integral of the irradiance, expressed in joules per square metre [J m-2];

18. Full load demand and actual speed ( 95 per cent reference speed

19. Prices start at about ￡100 per metre for standard models; fan-assisted convection designs are also available.

20. 17 Substance: One of the quality standards of paper, measured by weight in grams per square metre.

21. The Urns and Drapes fabric costs ￡50 per metre, and the porcelain plate costs ￡ all from Timney Fowler.

22. effective radiant exposure: radiant exposure spectrally weighted by S (λ), expressed in joules per square metre [J m- #]

23. The average absorptive capacity of household waste in landfill is 8.5 cm of liquid per metre of thickness.

24. radiant exposure (H): the time integral of the irradiance, expressed in joules per square metre (J m-2);

25. mg/m3 = milligrams per cubic metre of air at 20 °C and 101,3 kPa (760 mm mercury pressure).

26. In MKS units this would be W·m−2·sr−1·Hz−1 (watts per square-metre-steradian-hertz).

27. 26 The Urns and Drapes fabric costs ￡50 per metre, and the porcelain plate costs ￡ all from Timney Fowler.

28. Static axle load, mass per unit length and geometrical characteristics of axle spacing

29. Upon completion of the third load step, the engine shall be adjusted to engine speed C and # per cent load within # ± # s

30. Upon completion of the third load step, the engine must be adjusted to engine speed B and # per cent load within # ± # s

31. Magnetic fields depend on the flow of the electrical current and are measured in amperes per metre (A/m).

32. Static axle load, mass per unit length and geometrical characteristics of axle spacing ’.

33. Upon completion of the third load step, the engine must be adjusted to engine speed C and # per cent load within # ± # s

34. Upon completion of the third load step, the engine shall be adjusted to engine speed B and # per cent load within # ± # s

35. Chintz fabric / Darwin glazed cotton Chintz fabric by Titley and Marr priced per half metre and measures 137cm wide Knittypins

36. Four ALUs, two AGUs/load–store units, and two floating-point units per core.

37. It is located between 1450 metre and about 5000 metre above sea level.

38. No load demand and actual torque > ( 2 per cent of maximum torque (idle point)

39. Fig 2 — Total EU waste water load per agglomeration size, compared to treatment plants capacity

40. Static axle load, mass per unit length and geometrical characteristics of axle spacing (Section 4.2.3.2)

41. Upon completion of the third load step, the engine must be adjusted to the selected engine speed and any load above # per cent within # ± # s

42. 3.3.4. both load and deformation shall be measured to an accuracy of ± 1 per cent.

43. Upon completion of the third load step, the engine shall be adjusted to engine speed C and 10 per cent load within 20 ± 2 s.

44. Upon completion of the third load step, the engine shall be adjusted to engine speed B and 10 per cent load within 20 ± 2 s.

45. Electric field (volts/metre)

46. Upon completion of the third load step, the engine shall be adjusted to the selected engine speed and any load above # per cent within # ± # s

47. - or to compare two integrations of a load per unit length over the same time interval,

48. (d) Upon completion of the third load step, the engine shall be adjusted to engine speed B and 10 per cent load within 20 ± 2 s.

49. Cotton Blend Bengaline- Rainy Blue #4610 US$11.21 /metre BUY IN BULK: US$8.97 /metre

50. He later finished third in the 400-metre hurdles and fifth in the 4000-metre steeplechase.

51. He is a metre nothing.

52. Today there are the wall foundations of a rectangular building, a five-metre-long and 1.8-metre-side longitudinal wall, a four-metre-long and 0.4-metre-wide transverse wall which abuts on another wall that has yet to be uncovered.

53. It shall be possible to measure and read the indicated load to an accuracy of * # per cent

54. That means dealing with # to # per cent of the client load in some countries where we work

55. It shall be possible to measure and read the indicated load to an accuracy of ±# per cent

56. It shall be possible to measure and read the indicated load to an accuracy of ( 5 per cent.

57. It shall be possible to measure and read the indicated load to an accuracy of (5 per cent.

58. It shall be possible to measure and read the indicated load to an accuracy of ± 5 per cent.

59. It shall be possible to measure and read the indicated load to an accuracy of ±5 per cent.

60. On the fourth point, the claim for adjustment for quality differences was based on average weights per square metre of the Community and imported products.

61. There are 100 centimetres to the metre.

62. Give your answer to the nearest metre.

63. The 8844 - metre peak stabbed the sky.

64. The bird has a 1 - metre wingspan.

65. The metre is a unit of length.

66. We only sell it by the metre.

67. It will have 22 37-metre diameter wind turbines on 30-metre towers and generate enough electricity to supply 000 homes.

68. Absolute humidity is the mass of water vapour in a unit volume (this is water vapour density, commonly measured as grams of water vapour per cubic metre).

69. Many hymns have a firm, regular metre.

70. The ampere is that constant current, which if maintained in two straight parallel conductors of infinite length, of negligible circular cross-section, and placed one metre apart in vacuum, would produce between those conductors a force equal to 2 × 10-7 newton per metre of length.

71. Three feet is roughly equal to one metre.

72. Sediments are dominated by coarser (coarse sand/gravel) fragments, and the accumulation rate can be immense: up to 1 metre per year near the shores of larger lakes.

73. Who holds the 100 metre sprint record?

74. The metre is a measure of length.

75. Space the posts about a metre apart.

76. Previous record holders included the 162-metre (531 ft) National Flagpole in Azerbaijan, the 160-metre (520 ft) Panmunjeom Flagpole of Kijŏng-dong in North Korea, and the 133-metre (436 ft) Ashgabat Flagpole in Turkmenistan.

77. ‘The Becquerel is a unit of radioactivity and corresponds to one radioactive disintegration per second.’ ‘Information on demographic and lifestyle variables was compiled for each person by using a common format, and radon measurements were expressed in Becquerels (radon disintegrations per second) per cubic metre of household air.’

78. An ampere is a constant current which, if maintained in two straight parallel conductors of infinite length, of negligible circular cross-section, and placed one metre apart in a vacuum, would produce between those conductors a force equal to 2 × 10-7 newton per metre of length.

79. An ampere is a constant current which, if maintained in two straight parallel conductors of infinite length, of negligible circular cross-section, and placed one metre apart in a vacuum, would produce between those conductors a force equal to 2 × 10−7 newton per metre of length.

80. • sediment load – suspended and bed load