bending moment curve in Vietnamese

@Chuyên ngành kỹ thuật
@Lĩnh vực: xây dựng
-đường cong mômen uố

Sentence patterns related to "bending moment curve"

1. We're bending the curve.

Chúng ta đang bẻ cong nó.

2. Bending results from a couple, or a Bending moment M, that is applied

3. Bending: deforming force, which imposes tension on the outer curve and compression on the inner curve of a cylindrical body

4. Check of interference fit strained by additional radial force with bending moment.

5. Plastic hinge characteristic curves are a bending moment (M) — rotational angle (φ) relationship.

6. Points 4.5.1. (Strength test), 4.5.2. (Resistance to buckling) and 4.5.3. (Resistance to bending moment) only.

7. This force is necessary to create a bending moment that would be able to equilibrate the thermally induced moment due to the dissimilar adherends.

8. Performance limits for the tibia bending moment, the criteria ACL and MCL were presented to participants.

9. Bending synonyms, Bending pronunciation, Bending translation, English dictionary definition of Bending

10. Moreover, the influence of initial crookedness would be reduced as slenderness ratio and bending moment are increased.

11. The spanwise aerodynamic loading of wings having minimum induced drag is derived for prescribed lift and root-bending moment.

12. → adoption Curve → bell Curve → demand Curve → experience Curve → indifference Curve → yield Curve

13. dperm — lever of permissible moment taken from the dynamic stability curve, at the admissible heeling angle, m;

14. A Biaxial column is a column that is subjected to compressive axial force and bending moment in the two planes

15. The shear force and bending moment is initially calculated to determine the point where the Curtailment has to be done

16. Purpose: Critical bending moment (CBM), defined as the bending moment at which the external nonaxial load applied overcomes screw joint preload and causes loss of contact between the mating surfaces of the implant screw joint components, was measured for four different implants and their single-tooth replacement abutments.

17. Bending tool assembly for determining the bending angle

18. The rising takes place in and below the apparent peak of the bending zone. Nearly simultaneously a new curve displaced acropetally appears in the stalk.

19. Bending angle measuring apparatus and method for measuring a bending angle by means of the bending angle measuring apparatus

20. The bending moment at this section = Pcr.y The differential equation governing the small Buckling deformation is given by P y dx d y EI cr

21. Adequate correlation exists between bending MOE and bending strength with moisture content.

22. The curves bending moment vs curvature change are given and discussed for various parameters (ratio of axes A/B, normal pressure q, curvature parameter μ).

23. The Bending Iron maintains an even, thermostat-controlled heat for Bending wood

24. Liquid crystal display: Clapboard temperature curve, cry trapping temperature curve, sample temperature curve.

25. When the flexible lower legform impactor is used for a test according to paragraph 1.3.3, the absolute value of the maximum bending moment of the tibia at: