tensile bending test in Vietnamese

@Chuyên ngành kỹ thuật
@Lĩnh vực: xây dựng
-thí nghiệm kéo đứt do uố

Sentence patterns related to "tensile bending test"

Below are sample sentences containing the word "tensile bending test" from the English - Vietnamese Dictionary. We can refer to these sentence patterns for sentences in case of finding sample sentences with the word "tensile bending test", or refer to the context using the word "tensile bending test" in the English - Vietnamese Dictionary.

1. (4) Bending and tensile strength

2. Tensile strength and flexibility have been assessed with the aid of a four point bending configuration.

3. Static bending properties and tensile strength increased as fiber L/D increased from 3 to 26.

4. Force versus angle requirement in static lower legform impactor bending certification test

5. This is demonstrated in the introduction by means of a bending strength test.

6. Bending synonyms, Bending pronunciation, Bending translation, English dictionary definition of Bending

7. Points 4.5.1. (Strength test), 4.5.2. (Resistance to buckling) and 4.5.3. (Resistance to bending moment) only.

8. The pulling, or tensile resistance, test is also a test only for the draught type horses, and it measures pulling capacity in relation to size.

Việc kéo, hoặc kháng kéo, thử nghiệm cũng là một thử nghiệm chỉ cho những con ngựa thải loại, và các biện pháp kéo công suất so với kích thước.

9. The compressive surface stress is tough in the glass because any bending load has to overcome quenched compressive stress before there's a net tensile stress on the surface.

10. In addition to the adhesive test, bending strength, hardness, and colour of the modified timbers were examined.

11. A special test series investigated the effect on adhesion of a tensile or compressive stress state in a polyethylene pile.

12. Specimens that comprise or simulate special form radioactive material shall be subjected to the impact test, the percussion test, the bending test, and the heat test specified in 2.2.7.4.5 or alternative tests as authorised in 2.2.7.4.6.

13. Specimens that comprise or simulate special form radioactive material shall be subjected to the impact test, the percussion test, the bending test, and the heat test specified in 2.2.7.4.5 or alternative tests as authorized in 2.2.7.4.6.

14. Accordingly, the nano-hole electrode shows a very low change in electrical resistance during a bending fatigue test.

15. The texture evaluations of restructured meats are measured by texture profile analysis (TPA), expressible water percent, tensile strength and puncture test.

16. Bending tool assembly for determining the bending angle

17. To this end the instrumented notched bar impact bending test is performed on unirradiated samples of the pressure vessel steel.

18. The Biaxial tensile test is primarily performed in research and development to investigate defined stress values at the intersection point of the specimen

19. Viscosity, elasticity, and tensile strength.

20. Bending angle measuring apparatus and method for measuring a bending angle by means of the bending angle measuring apparatus

21. Key words: concrete, accelerated strength, tensile strength, admixtures, curing, splitting tensile strength, modulus of rupture, strength correlations.

22. Bslm-8BP-62: Typical Tensile Values

23. Filament density steady and tensile force.

24. Adequate correlation exists between bending MOE and bending strength with moisture content.

25. The Bending Iron maintains an even, thermostat-controlled heat for Bending wood