signal-to-noise ratio in English

noun
1
the ratio of the strength of an electrical or other signal carrying information to that of interference, generally expressed in decibels.
Maintaining a high signal-to-noise ratio requires high-sensitivity position detectors and low-noise electronics.
noun
    signal-to-noise

Use "signal-to-noise ratio" in a sentence

Below are sample sentences containing the word "signal-to-noise ratio" from the English Dictionary. We can refer to these sentence patterns for sentences in case of finding sample sentences with the word "signal-to-noise ratio", or refer to the context using the word "signal-to-noise ratio" in the English Dictionary.

1. Multi-valued read-only storage location with improved signal-to-noise ratio

2. The Binned example also highlights how binning improves signal to noise ratio

3. The signal-to-noise ratio determines the of telecommunication systems (e.g., radio receivers).

4. However, note that reducing the shunt resistance will degrade the signal - to - noise ratio.

5. Integrating analog to digital conversion and digital smoothing will improve the signal to noise ratio.

6. Four observations were excluded because of low signal-to-noise ratio or background subtraction problems.

7. Biasing and erasing apparatus and method for a magnetic tape recording device to improve signal-to-noise ratio

8. The signal to noise ratio of data signal and tracking error signal are improved at the same time.

9. The IF- Amplifier of a radar receiver determines the gain, signal-to-noise ratio, and effective bandwidth of the receiver.

10. It is possible to detect individual pulses from this millisecond pulsar with high signal-to-noise ratio in unbroken trains.

11. In case of agglomerated yeast cells the signal-to-noise ratio was significantly increased in comparison to Raman spectra of the suspension.

12. Moreover, in the range between 900 nm and 1000 nm, InGaAs has a much better signal to noise ratio than Ag-O-Cs.

13. Minimizing sampling of the adipose layer greatly reduces interference contributed by the fat band in the sample spectrum, increasing signal-to-noise ratio.

14. Antenna Arraying is the combining of the output from several antennas in order to improve the signal-to-noise ratio (SNR) of the received signal

15. Antenna Arraying is the combining of the output from several antennas in order to improve the signal-to-noise ratio (SNR) of the received signal

16. The ability to count every photon absorbed not only takes the signal-to-noise ratio to its quantum limit but would also facilitate decreased doses of radiation.

17. In addition, Audigy 2 supported up to 6.1 (later 7.1) speakers and had improved signal-to-noise ratio (SNR) over the Audigy (106 vs. 100 decibels (A)).

18. It utilizes spectral envelope estimation to obtain envelope and peak signal and calculates signal-to-noise ratio of speech harmonics in iterate form under least square estimate criterion.

19. These have already resulted in an ADC with significant increases in signal-to-noise ratio (SNR, an indication of the ‘power’ of the signal compared to the noise) relative to conventional systems.

20. While strain/strain rate imaging offers very precise analysis of regional left ventricular function, it also requires intensive postprocessing, is limited by an unfavorable signal to noise ratio and a major angle dependency.

21. In order to use the statistic dependencies available in the source signal for another gain in the signal-to-noise ratio, the differential pulse code modulation (DPCM) is combined with spherically logarithmic quantization.

22. Pixel Binning is the process of combining the electric charge from adjacent CMOS or CCD sensor pixels into one super-pixel, to reduce noise by increasing the signal-to-noise ratio in digital cameras.

23. Later in the logs, there's additional information about the strength of the available connections, including the MAC address of the access point, frequency of the signal, noise and signal levels, and signal-to-noise ratio:

24. An introduction to antenna Arraying in the Deep Space network Antenna Arraying is the combining of the output from several antennas in order to improve the signal-to-noise ratio (SNR) of the received signal

25. Pixel Binning is a clocking scheme used to combine the charge collected by several adjacent CCD pixels, and is designed to reduce noise and improve the signal-to-noise ratio and frame rate of digital cameras

26. The application of window function as a tool for lineshape correction and signal-to-noise ratio (SnR) enhancement is rarely discussed in Chirped spectroscopy, with the only exception of using Kaiser-Bessel window and trivial rectangular window

27. The internal scatter of the Abundances within clusters indicates that abundance precision is generally between 0.05 and 0.09 dex across a broad temperature range; it is smaller for some elemental Abundances within more limited ranges and at high signal-to-noise ratio.

28. The improvement of the signal-to-noise ratio and the contrast-amplification leads to a sensitivity at least 10 times greater for the system of the visual cells 1–6 than for the visual cells 7 and 8 when these are compared on the level of the lamina ganglionaris.

29. Up to 4% cash back  · Pyramid Car Audio PB717X Arctic Series 2-Channel Bridgeable Class AB Amp (1,000 Watts), Class AB, 1,000W Max, 2 Channels, Bridgeable, MOSFET PWM Power Supply, Signal-to-noise Ratio: 90dB, THD: This arctic series 2-channel Bridgeable class ab amp (1,000 watts) is a high quality receivers & amplifiers item from our automotive, marine & gps , automotive speakers & …