1. Structural steel piles with hollow sections and rigid splices

2. All field splices were bolted using ASTM A 325 hex head bolts.

3. Then we might get together for a mini-lesson on, say, comma splices.

4. BURNDY Crimpers are designed to crimp lugs, splices and C-tap or H-tap connections

5. 1951, Film Music (volumes 11-12, page 23) […] and the track abounds in unBlooped splices

6. Heat activated splice kits for environmentally sealing electrical conductor splices and methods of using same

7. Rail splices shall be welded and ground smooth except where expansion splice locks are required.

8. In each case the splices result in appropriate splice junctions and a single open reading frame.

9. The joints between modules were staggered vertically, so the column splices between adjacent modules were not at the same floor.

10. This quality one-step Connector is filled with a dielectric silicone sealant that surrounds splices, making it water and corrosion resistant

11. Hickman Edge Systems PermaSnap Coping is ANSI/SPRI/FM 4435 ES-1 tested for use on parapet walls up to 32-inches wide. The three-piece system includes self-locating pre-punched clips, concealed splices with integral gutter system, and snap-on cap for rooftop productivity.

12. In tension lap splices, the benefit provided to the lap by stirrups placed to intercept longitudinal cracking due to bond splitting action is recognized by the American Concrete Institute code (ACI 318-89) and the design recommendations of ACI Committee 408, on which the American code provisions are partially based.

13. Abeam length containing two 50-cm long overlapping splices under constant bending moment is experimentally investigated with the following objectives: examine flexural and splitting crack openings along the splice length; determine the splice strength; study the effective stiffness of the beam length containing the splice, especially during the cracked stage.

14. Bolted Field Splices for Steel Bridge Flexural Members / 1 1 INTRODUCTION A splice is defined in AASHTO LRFD Article 6.2 as a group of Bolted connections, or a welded connection, sufficient to transfer the moment, shear, axial force or torque between two structural elements joined at their ends to form a single, longer element.

15. A second cleaning threshold, which is dependent on the at least two parameters of the test material and differs from the first cleaning threshold, between admissible and inadmissible splices in the test material is automatically calculated from the first cleaning curve, represented in a diagram as a second cleaning curve (16) and transmitted to the measuring head.