1. Specific heat content is high, good heat conduction.

2. The results show that as heat rate increases, he specific heat of glass with higher energy.

3. Amorphous solids do not have any specific heat of fusion

4. Numerical results are compared with available experimental data for adiabatic compressibility, the linear thermal expansion coefficient, specific heat at constant volume, and specific heat at constant pressure.

5. What is the specific heat of the metal in the pan?

6. Heat analysis—the chemical analysis determined by the steel producer as being representative of a specific heat of steel.

7. But the specific heat of water transfer printing technology transfer process complicated.

8. One of the key properties of an encapsulated thermal battery is its volumetric heat capacity (VHC), also termed volume-specific heat capacity.

9. The following specific definitions apply to aggregates for electricity and heat in this chapter:

10. It is found that the results are influenced greatly by specific heat of air.

11. The following specific definitions apply to aggregates for electricity and heat in this chapter

12. The specific heat of nanocrystal approaches that of glass, but is that of bulk crystals.

13. Specific and persistent activation of heat shock response in cell lines using a viral factor

14. The following table charts of typical convective Convection heat transfer coefficients for fluids and specific applications

15. The outcome of the experiment shows the specific heat of dry wood is independent on species.

16. A hypothesis was presented that the specific heat of resin changed greatly at the gel point.

17. However, evidence on the heat- and cold-Attributable mortality burden from other specific causes is limited

18. Is Making the Liquid Thermometer with Mercury Just be Cause the Latter Has Small Specific Heat?

19. Thermal conductivity, thermal diffusivity and volume specific heat were studied using the transient plane source method.

20. The product of a solid element's relative atomic mass and its specific heat capacity is approximately

21. — cair is the specific heat capacity of air at constant pressure and density [kWh/(m3 K)];

22. Specific volume, specific heat capacity, thermal expansion coefficient and adiabatic compressibility coefficient for both water and ice must be known at any temperature and pressure combination.

23. The contributions by the specific molecular interaction of benzene to its adsorption heat were compared for different adsorbents.

24. ·K. The specific heat capacity varied with the aggregate source and ranged from 940 to 2000 J/kg

25. At night, the land cools off more quickly than the ocean because of differences in their specific heat values.

26. A calculation formula for determining the specific heat capacity of solid with an improved RD496-III microcalorimeter was derived.

27. A particle potential energy is introduced to make the model suitable for the perfect gas with arbitrary specific heat ratio.

28. Maize seedlings respond to heat shock, water stress, abscisic acid treatment, and wounding with the synthesis of stress-specific proteins.

29. Classical adiabatic methods for measuring specific heat in a wide temperature range are very suitable for homogeneous, well defined materials.

30. An adiabatic calorimeter suitable for specific heat measurement of solids and liquids of poor thermal conductivity for the temperature range −80...

31. Heat regenerators, heat accumulators, heat pumps, heat exchangers, in particular plate heat exchangers, counterflow exchangers, countercurrent exchangers

32. Stress-relief Annealing, partial Annealing, and full Annealing employ the different temperatures and cooling rates specific to each heat treatable alloy

33. Annealing is a heat process whereby a metal is heated to a specific temperature /colour and then allowed to cool slowly

34. Gases: ideal gases laws; specific heat at constant volume and constant pressure, work done by expanding gas; Isothermal, adiabatic expansion and compression, engine cycles, constant volume and constant pressure, refrigerators and heat pumps; Latent heats of fusion and evaporation, thermal energy, heat of combustion.

35. An actual compression ratio is changed according to the specific heat ratio of an intake gas that is supplied into a cylinder.

36. Heat regenerating systems with heat accumulators, and with heat exchangers

37. Heat exchangers, heat exchanger systems, heat pumps, heat accumulators and parts for the aforesaid goods

38. The specific heat of rare earth nitrides has been measured at temperatures between 1.7 ans 270°K by means of an adiabatic calorimeter.

39. A shrinkable copolyester film having shrinkage of not less than 30 % in either the machine direction or transverse direction after specific heat treatment.

40. Bedwarmers (heaters), Footwarmers (electric or non-electric),Curling lamps (heat lamps), Hot water bottles, Heat exchangers, Heat accumulators, Heat regenerators, Heat pumps, Plate warmers, Pocket warmers, Solar modules for heat generation, Parabolic troughs for heat generation

41. Heat exchangers, in particular plate heat exchangers, heat pumps, heat regenerators and heat accumulators, and parts for the aforesaid goods, included in class 11

42. Heating apparatus, heating installations, air conditioning installations, heat regenerators, heat accumulators, heat exchangers

43. Heat or cold storage devices, heat accumulators

44. Gas and electric heat accumulators, heat regenerators

45. Heat exchange module using latent heat material and heat accumulator system incorporating the same

46. Auxiliary heat on the other hand uses heat strips together with the heat pump to supplement the loss of heat

47. Heating installations, heat accumulators, heat exchangers, heat pumps, coils, thermostatic valves, water heaters, water supply installations, heat transfer devices, kettles, boilers

48. A transient method with rectangular pulse heating has been developed to measure the specific heat and thermal conductivity of solid structural materials at low temperatures.

49. This paper discussed the assessment of uncertainty of air's specific heat capacity ratio, and gave a method of more reasonable, standard and easy for teaching.

50. Blistering definition: Blistering heat is very great heat

51. Method of heat accumulation and heat accumulation system

52. Brazed Plate Heat Exchangers; Brazed Plate Heat Exchangers

53. Vacuum double heat insulation container for heat retaining

54. Heat a lightly greased skillet over medium heat.

55. The efficiency of sensible heat and latent heat of rotate wheel heat exchanger were illustrated.

56. (New Products) The reaction Calorimeter is one of four calorimetry techniques that measure the amount of heat generated in, or emitted by, materials in specific processes.

57. In 1910, Einstein pointed out the anomalous behavior of specific heat at low temperatures as another example of a phenomenon which defies explanation by classical physics.

58. Generator-absorber-heat exchange heat transfer apparatus and method and use thereof in a heat pump

59. Heat pumps, air/water heat pumps, air/water heat pumps for installation by specialised professional operators

60. The heat benchmark is applicable for heat consumption processes where a measurable heat carrier is used.

61. Heat insulating panel with active regulation of heat transition

62. Heat Bammy griddle or fry pan over moderate heat

63. Heat exchanger, air conditioner, and heat exchanger manufacturing method

64. Endothermic reactions absorb heat, while exothermic reactions release heat.

65. Absorption type heat supply system and heat supply method

66. Useing for asthma, heat dysentery, heat stranguria, and carbuncle.

67. Electric household apparatus, namely solar collectors, air conditioning installations, heat accumulators, heat regenerators, ventilating apparatus, heat pumps

68. Heat pumps, air heaters, heat accumulators, heat regenerators, radiators, electric or otherwise, solar collectors and fittings therefor

69. By using improved variational method, the internal energy per plaquette and the specific heat curves of the Tangent action in SU lattice gauge theory arc worked out.

70. Accordingly, the heat benchmark was defined for heat consumption processes where a measurable heat carrier is used.

71. Heat pump type chiller and heat pump type air conditioner

72. System powered by combination of heat engine and heat pump

73. Heat exchanger; Radiative Cooling in Heat shields; Radiators in automobiles

74. 30 Remove from the heat and let rest. Heat the butter in a frying pan over low heat.

75. Heat accumulators, steam accumulators, absorption storage tank accumulators (heat accumulators)

76. whose outdoor side heat exchanger (condenser) releases this heat to ambient air, water or ground heat sink(s);

77. Specific promoters are activated in specific cells.

78. A Stirling engine system has at least one heat source, one heat sink and up to five heat exchangers.

79. The Janome Elnapress Artistic Heat Press Model EP100 is ideal heat

80. Heat recovery Heat recovery on kitchens refrigerators and air conditioning plant.