1. Phase evaluation is carried out in order to calculate a target deviation angle &agr;z .

2. 13 It is essential for GPS receiver verification to detect the phase center deviation of antenna.

3. This test shall cover the following matters: voltage, frequency, phase angle range, deviation of voltage and frequency.

4. The peak of the wave celerity probability distribution appears mean velocity region of the two - phase flow.

5. The variation of minute bubbles is monotonic, whereas there is peak for the case of phase splitting drop.

6. Frequency deviation:

7. Absolute standard deviation

8. Peak power = (peak potential in volts) × (peak beam current in amperes).

9. Absolute Deviation (£s)

10. ‧Peak power‧ = (peak potential in volts) × (peak beam current in amperes).

11. Peak power» = (peak potential in volts) × (peak beam current in amperes).

12. In the five-phase machine, for example, the highest peak static torque is obtained when two or three phases are excited.

13. “Peak power” = (peak potential in volts) × (peak beam current in amperes).

14. 'Peak power' = (peak potential in volts) x (peak beam current in amperes).

15. ‘Peak power’ = (peak potential in volts) x (peak beam current in amperes).

16. ‘Peak power’ = (peak potential in volts) × (peak beam current in amperes).

17. "Peak power" = (peak potential in volts) × (peak beam current in amperes).

18. The first number is local deviation in hertzs, i.e. maximal deviation from current frequency.

19. 'Peak power' = (peak potential in volts) × (peak beam current in amperes).

20. [Peak power = (peak potential in volts) x (peak beam current in amperes).]

21. Peak power = (peak potential in volts) x (peak beam current in amperes).

22. It's the deviation factor.

23. absolute standard deviation (m–1)

24. The variance and standard deviation are Schur-convex functions, while the Median absolute deviation is not.

25. Phase Jitter: refers to the deviation of the FBKCLK rising edge to the REFCLK rising edge with respect to the average offset in a random sample of cycles.

26. Amole Peak rises on the western ridgeline of Wasson Peak, the highest peak in the area

27. (19) WMAD: Weighted mean absolute deviation.

28. 8. microprocessors to calculate the cardinal points (beginning of peak, end of peak and top of peak);

29. Based on the deviation (Δi) between the target absolute current value (|i|*) and an actual absolute current value (|i|), a feedback control section (155) computes a phase angle (θFB).

30. Calculating standard deviation step by step

31. This thesis mainly discusses the multi-carrier phase code (MCPC) pulses signal, and the design of pulses trains with low peak-mean envelop power ratio (PMEPR).

32. A quadratic phase factor and DOG wavelet transform function are introduced into traditional matched filter to sharpen correlation peak, which is fabricated by computer generated hologram.

33. The average deviation is ±0.02% (absolute).

34. Actual value with some deviation from target

35. Analogously, the weighted standard deviation is calculated.

36. Beach Side Bombastics (himbofication tg) Deviation Actions

37. • Mean absolute deviation from target (MADT).

38. The boring direction deviation is thus continuously changed preventing significant deviation accumulation and producing a substantially straight segment of the borehole.

39. Deviation from the norm is not tolerated.

40. Dragontail Peak/Triple Couloirs

41. Phase II The timing of the third phase will depend on the outcomes of Phase I and Phase II.

42. A compound containing two Bromines will have a [M + 2] peak twice the size of the [M +] peak and a [M + 4] peak the same size as the [M +] peak (Figure 6.6a)

43. Single Phase and Three Phase Autotransformers

44. Aggregate peak demand (67)

45. Multi-peak speech processor

46. Peak Current: 20,000 amperes

47. - usage charges which may, inter alia, take account of peak and off-peak periods.

48. Constantly definition is - without variation, deviation, or change : always

49. Any deviation from these criteria makes it non-Aromatic.

50. However, an unreasonable deviation brings s.12 into play.

51. The 3 deg. deviation flight path doomed this airliner.

52. It's peak season rate.

53. Furthermore, the present application discloses X-ray diffraction characteristic absorption peak and IR absorption peak.

54. Standard deviation of comparability SR = 2,50mg/100 g.

55. Maximum deviation (absolute value) from the calculated mean

56. There was little deviation from his usual routine.

57. An iron - spiked stick in hand he roamed at will , wandering from peak to peak .

58. Blackcap is a rugged peak closely linked with higher Monument Peak to the south

59. Peak to peak Amplitude is the difference between the positive and the negative peaks

60. Carrier-phase adjustment using absolute phase detector

61. Peak ® Aluminium Balustrade System

62. They have reached peak water.

63. 17 There was little deviation from his usual routine.

64. Abnormality definition, an abnormal condition, state, or quality; irregularity; deviation

65. Any result outside of this may be considered a deviation.

66. 17 A business cycle can be measured from peak to peak or from trough to trough.

67. Actual value with deviation from target above acceptable range

68. Deviation based antenna control algorithm for an access point

69. As they build phase 1, they design phase 2.

70. This definition includes Phase I to Phase IV trials.

71. Average deviation between actual and budgeted expenditure on administrative basis

72. See Clear cell Adenocarcinoma, Minimum deviation Adenocarcinoma of the endocervix

73. Average absolute deviation between predicted and observed values is ca.

74. Peak expiratory air flow meters

75. Four klicks west, highest peak...

76. Azeotropes form when there is a 'deviation from Raoult's law': A solution that shows positive deviation from Raoult's law forms a minimum boiling azeotrope

77. Mean deviation, standard deviation and variance of the poles are defined about the best axis and the best zone of an accumulation of poles.

78. The causes of diagonal deviation of straight angle cutter were examined from all aspects of the situation. The measures of deviation-controlling was recommended .

79. Peak Amplitude is the difference between the mid-point of the signal and the positive peak

80. A Bumpiness coefficient of 100 means “one standard deviation”