1. Geothermal adiabatic-isothermal heat sink exchange system

2. Refrigerating and isothermal cabinets and chambers, cold accumulators

3. The result was extremely positive: perfect isothermal and maximum aerodynamicists.

4. This buffer provides superior reaction conditions for isothermal Amplication applications

5. Adsorption–desorption isotherms and isothermal calorimetric heats of adsorption were measured.

6. The isothermal data for adsorption followed the Freundlich and Langmuir models.

7. The heat of adsorption of CO2 and C2H4 was determined by isothermal calorimetry.

8. The Compressibility of a fluid depends on adiabatic or isothermal process.

9. In contrast, free expansion is an isothermal process for an ideal gas.

10. This paper presents a mathematical model of calculating gas isothermal compressibility factor.

11. The boundary conditions were: Two isothermal walls at different temperatures, two horizontal adiabatic walls.

12. Isothermal, adiabatic expansion and compression, engine cycles, constant volume and constant pressure, refrigerators and heat pumps;

13. Methods for operating such a system under adiabatic, isothermal, isobaric and isochoric conditions are described.

14. It can replace traditional isothermal anneal as advance heat treatment of roughcast of bearing rings.

15. Loop-mediated isothermal Amplification (LAMP) uses 4-6 primers recognizing 6-8 distinct regions of target DNA

16. The thermal decomposition of ferrous sulphate heptahydrate was carried out in air under dynamic and isothermal conditions.

17. In fluid mechanics and thermodynamics, Compressibility is also known as isothermal Compressibility or coefficient of Compressibility

18. We show that with increasing frequency, a transition from an isothermal to an adiabatic process occurs.

19. 27 Isothermal normalization can improve or eliminate the banded structure and duplex grain structure in forging blanks.

20. Isothermal remanent magnetization (IRM) acquisition and subsequent thermal demagnetization indicate that pyrrhotite is the dominant ferrimagnetic mineral.

21. The activation energy for dehydration of these four compounds has been calculated using non-isothermal thermogravimetric data.

22. FRAME: 170 A shallow lapse rate, an isothermal layer, or an inversion, is an indication of stable air.

23. The obtained kinetic data are the basis for computation of a reaction process under any condition, e.g. isothermal or adiabatic.

24. The most common types of Calorimeters are differential scanning Calorimeters, titration Calorimeters, isothermal micro Calorimeters, and accelerated rate Calorimeters.

25. Rolling circle amplification (RCA) is an isothermal nucleic acid amplification method which is simple, rapid, highly sensitive and specific.

26. The reaction ordern=1 and the values of the activation energy agreed with the results of isothermal experiments.

27. The a.c. resistance is found to be in general different from the isothermal or the steady-state differential resistance.

28. A temperature difference is imposed between the two isothermal end walls and the other two walls are assumed to be adiabatic.

29. Within less than 1 millisecond the steep- fronted shock wave has traveled some distance ahead of the isothermal region.

30. The thermal decomposition of [Co(NH3)5Cl]Cl2 was studied under non-isothermal conditions, in dynamic air and argon atmospheres.

31. The isothermal decomposition and reduction of ammonium polyuranate (ADU) was investigated in the temperature interval 285–463° C in hydrogen.

32. Engine embodiments primarily designed for aircraft propulsion and power generation incorporating the Carnot cycle for efficient combustion with typical embodiments including air compressors having one or more stages with isothermal compression and including combustion and expansion chambers having in part isothermal expansion before final adiabatic expansion.

33. The records reveal three consecutive phases in the development of the fog: i. inversion; ii. isothermal state; iii. approximately saturated-adiabatic lapserate.

34. Boundary layer analysis is performed for free convection in a saturated porous medium adjacent to non-isothermal vertical impermeable surfaces.

35. An estimation is given of the harmonic content of the pressure waveform under the limiting conditions of isothermal and adiabatic compression.

36. The crystallization behaviors of Acetylated bamboo fiber (BF)/polypropylene (PP) composites were assessed using differential scanning calorimetry (DSC) through isothermal crystallization

37. DTA and isothermal kinetic studies were carried out on the reactions of BaSO4 or BaCO3 with TiO2 (anatase and rutile) to BaTiO3.

38. A single-step, isothermal strand displacement amplification method that is conducted without the requirement for heat denaturation of the target nucleic acid.

39. MDA is an isothermal, strand-displacing Amplification yielding about 20-30 microg product from as few as 1-10 copies of human genomic DNA.

40. We were able to accomplish this by developing a procedure that I tried to call the "one-step isothermal in vitro recombination method."

41. The asymptotic stability of the rarefaction wave has been established for the impermeable wall problem under small perturbation conditions and non-isothermal conditions.

42. Learn about isothermal Amplification, compare differences between LAMP and PCR, and how Phi29 DNA polymerase is the main enzyme of choice for WGA

43. 13 Calculation showed that the isothermal combustion temperature of pulverized coal furnace and the fluidized bed temperature decreased when the steam load produced by the bark increased.

44. Using adiabatic temperature changes and isothermal pressure changes for gas processing and separation, large amounts of required energy are internally recycled using electric and heat distribution lines.

45. For the two limiting cases, adiabatic and isothermal flow, the difference in the mass-flow rate at the broken end has been found to be very small.

46. The activation energy is calculated from the slope of the logarithm of the maximum peak height of the isothermal DTA trace versus the reciprocal of the absolute temperature.

47. Shortcomings in the simple interpretation of adiabatic data are identified and isothermal heatflow calorimetry is used to reveal autocatalytic effects which were not apparent from the adiabatic experiments.

48. An experimental study was carried out on the mean aerodynamic and heat-exchange characteristics of a weaklyheated air jet flowing over an isothermal and an insulating flat surface.

49. Non-isothermal thermogravimetric measurements were employed to obtain values of experimental activation energy and entropy for the dehydration of CuSO4 · 5 H2O, CuSO4 · 3 H2O and CuSO4 · H2O.

50. NASBA: Nucleic acid sequence-based Amplification is a method used to amplify RNA.: LAMP: Loop-mediated isothermal Amplification is a single tube technique for the Amplification of DNA

51. In fluid mechanics: Basic properties of fluids …this is described by the Compressibility of the fluid—either the isothermal Compressibility, β T, or the adiabatic Compressibility, β S, according to circumstance

52. The concentration distribution of pulverized coal in blowpipe of blast furnace was measured in an isothermal two-phase model by means of a computer measuring system based on infrared transmission.

53. The heat transfer in this system is studied by assuming the glazing and the vertical bounding wall isothermal at different temperatures, two horizontal bounding walls adiabatic and porous layer without vents.

54. The apparatus provides concentrations of alumina, total caustic and total alkali by relying on accurate determination of liquor temperature, density, sound velocity, conductivity and maximum conductivity of the liquor under isothermal dilution.

55. It is demonstrated that the results obtained by the traditional methods of non-isothermal kinetics depend on the heating rate, whereas the results attained by affine transformation are independent of the heating rate.

56. The isothermal adsorption and desorption of water vapor by forest fuels is represented with a two-parameter model based on an exponential relationship between Gibbs free energy change and equilibrium moisture content.

57. The present paper describes the experimental setup and the grain size analysis. Finally, results for the isothermal annealing of three different plain carbon steels at 950, 1050, 1150, and 1250 °C are briefly discussed.

58. The Cue COVID-19 Test is a molecular in vitro diagnostic test that aids in the detection and diagnosis SARS-CoV-2 and is based on widely used nucleic acid isothermal amplification technology.

59. It uses rarefied gas in a novel three-phase cycle, of which the first phase is a spontaneous isothermal gas aggregation (0----1), equivalent to an ideal isothermal compression, followed by an adiabatic expansion (1----2), with work produced at the expense of the internal thermal energy of the gas via a gas turbine (5), and by an isobaric expansion (2----0)), where the expanded gas is reheated via a heat excanger (6), while cooling the ambient air (7).

60. In thermodynamics and fluid mechanics, Compressibility (also known as the coefficient of Compressibility or isothermal Compressibility) is a measure of the relative volume change of a fluid or solid as a response to a pressure (or mean stress) change

61. Chemical shrinkage is like a molecular-level volume change, and creates the underlying driving force for the occurrence of Autogenous shrinkage that is the macroscopic bulk deformation of a closed, isothermal, cementitious material system not subjected to …

62. In an effort to provide insight into the mechanism of Ca2+-induced fusion of lipid vesicles, molecular dynamics simulations in the isobaric−isothermal ensemble are used to investigate interactions of Ca2+ with Apposed lipid bilayers in close proximity

63. Compressible Flow ¶ fluids.Compressible.isothermal_gas (rho, fd, P1 = None, P2 = None, L = None, D = None, m = None) [source] ¶ Calculation function for dealing with flow of a Compressible gas in a pipeline for the complete isothermal flow equation

64. A perturbation solution is given for the special case of aNewtonian liquid with pressure and temperature dependent viscosity and expressions for the velocity components, pressure distribution and flow rate are obtained for both isothermal and adiabatic wall conditions.

65. Gaseous nitrogen Actuates a Carnot power cycle in which the respective volumes at the four corners of the cycle, starting at the beginning of the isothermal expansion, are V, = 10.10 L, V, = 14.53 L, V=226.54 L, and V, = 157.73 L

66. Isothermal (electric, gas, direct steam, steam to steam and liquid to steam) humidifiers and adiabatic (atomizing air and water and evaporative) humidifiers for use in HVAC or industrial, commercial or residential applications as well as installed into any equipment or appliance

67. 3.Gaseous Nitrogen Actuates a carnot power cycle in which the respective volumes at the four corners of the cycle, starting at the beginning of isothermal expansion are V1 = 10.10 liters, V2 = 14.53 liters, V3 = 226.54 liters and V4 = 157.73 liters.

68. A calorimeter is an object used for Calorimetry, or the process of measuring the heat of chemical reactions or physical changes as well as heat capacity.Differential scanning calorimeters, isothermal micro calorimeters, titration calorimeters and accelerated rate calorimeters are among the most common types

69. Isothermal infiltration of highly polymerized fluids would explain the shift in the affinity and affinity rate of the Antigorite dehydration reaction, as well as the olivine morphology tabular on (100) due to the inhibited growth on the (100) and, to a lesser extent, (010)

70. Rigorously, the modes become uncoupled only for the special cases of isothermal and adiabatic boundary conditions: approximately, however, they are uncoupled even in the general case if the analysis is confined to the lowest-order terms in the small dimensionless frequency associated with such problems.

71. The WarmStart Colorimetric LAMP 2X Master Mix is an optimized formulation of Bst 2.0 WarmStart DNA Polymerase and WarmStart RTx in a special low-buffer reaction solution containing a visible pH indicator for rapid and easy detection of Loop-Mediated Isothermal Amplification (LAMP) and RT-LAMP reactions.

72. Gases: ideal gases laws; specific heat at constant volume and constant pressure, work done by expanding gas; Isothermal, adiabatic expansion and compression, engine cycles, constant volume and constant pressure, refrigerators and heat pumps; Latent heats of fusion and evaporation, thermal energy, heat of combustion.

73. The WarmStart Colorimetric LAMP 2X Master Mix is an optimized formulation of Bst 2.0 WarmStart DNA Polymerase and WarmStart RTx in a special low-buffer reaction solution containing a visible pH indicator for rapid and easy detection of Loop-Mediated Isothermal Amplification (LAMP) and RT-LAMP reactions.

74. The Compressibility (also known as the coefficient of Compressibility or isothermal Compressibility is a measure of the relative volume change of a fluid or solid as a response to the application of pressure and is expressed as: β = (1 / V)(δV / δp) In this equation, where V is …

75. 2; 2014 ISSN 1927-0909 E-ISSN 1927-0917 Published by Canadian Center of Science and Education Sorption of Heavy Metals by Ferralic-Arenosol and Vertic-Luvisol: A Comparative Isothermal Study Tlou Mosekiemang1, Oagile Dikinya2 & Elisha Toteng2 1 Department of Chemistry, University of Botswana, Gaborone, Botswana 2 Department of …

76. The Compressibility is a thermodynamic quantity of interest not only from a static but also from a dynamic point of view. Its relevance to the biological function of a protein can be understood through the statistical mechanical relation between the isothermal Compressibility β T, and volume fluctuations: (5) 〈 δ V 2 〉 = k B T V β T