superheat temperature in Vietnamese

@Chuyên ngành kinh tế
-nhiệt độ quá nhiệt
@Chuyên ngành kỹ thuật
@Lĩnh vực: hóa học & vật liệu
-nhiệt độ quá nhiệt

Sentence patterns related to "superheat temperature"

1. 11 Furthermore, casting speed, superheat and cooling waters effects on steady temperature field are analyzed in this paper.

2. An actual superheat value in a refrigerant system is compared to an expected superheat level.

3. 8 Has designed one boiler superheat vapor temperature online fuzzy PID double model control method based on this, and has given the detailed design proposal.

4. 30 With the increase of inlet air temperature of the condenser, evaporation pressure, condensation pressure increase, but supercooling and superheat degree, refrigerating capacity and COP decrease.

5. Otherwise, the solidification structure for different superheat was simulated.

6. 24 The experience was conducted using cooling slope and low superheat processes, effects of pouring temperature and the degree of slope on the billet's structure were researched.

7. 4 Otherwise, the solidification structure for different superheat was simulated.

8. 29 It is illustrated that discharge temperature of gas cooler, efficiency of expander and degree of superheat at the inlet of compressor can exert more influence on the optimum high pressure.

9. 6 The container may burst up if you superheat It'so much.

10. Uneconomic industrialized Jared specks Aphoriser traverses superheat coarsely! Alight Joe chloridizing, Buy Ardin Diazepam bowdlerizes recollectedly

11. 14 Maximum wall superheat does not always exist at the top of the boiling surface.

12. 9 The effect of the superheat is much slighter than that of above mentioned factors .

13. The superheat brings the temperature ratio (T2/T1) of the power output turbine into equality with the pressure ratio (P2/P1)(K-1)/K to effect a highly efficient and adiabatic isentropic expansion across the power output turbine.

14. However, excessive P addition results in a larger degree of superheat of the melt, hence aggravating the oxidation.

15. 22 However, excessive P addition results in a larger degree of superheat of the melt, hence aggravating the oxidation.

16. 10 Superheat treatment can change state of the melt obviously, consequently affects the final structure and properties.

17. 1 Don't superheat the anger of the mass. Otherwise you will not be able to control them.

18. 17 There easily exists shrinkage porosity due to superheat of ingate root in large plain parts investment casting.

19. Liquid crystal display: Clapboard temperature curve, cry trapping temperature curve, sample temperature curve.

20. Ambient temperature: Store at the surrounding temperature

21. Initial temperature : ( 200 °C (beginning at room temperature)

22. Initial temperature: ≤ 200 °C (beginning at room temperature)

23. 16 In the superheat cycle, the saturated dry steam leaving the boiler drum is further heated before entering the turbine.

24. Initial temperature: ≤ 300 °C (beginning at room temperature)

25. 26 The results show that the steel liquid is cooled down by cooling roller and the pouring with low superheat is realized.