sequence of test in Vietnamese

@Chuyên ngành kỹ thuật
-trình tự thử nghiệm

Sentence patterns related to "sequence of test"

Below are sample sentences containing the word "sequence of test" from the English - Vietnamese Dictionary. We can refer to these sentence patterns for sentences in case of finding sample sentences with the word "sequence of test", or refer to the context using the word "sequence of test" in the English - Vietnamese Dictionary.

1. Test sequence

2. Sequence of ELR test

3. Test conditions and sequence

4. TEST SEQUENCE AND FUEL

5. Test sequence number five.

6. Sequence of the parts of the test

7. (b) Test sequence and cycles

8. Test sequence - M1 and N1 categories of vehicles

9. That completes the minefield test sequence.

10. The following flow chart outlines the test sequence:

11. The following flow chart outlines the test sequence.

12. Test sequence OVC-HEVs in accordance with option 4

13. The test sequence shall be started, if the engine has reached idle speed.

14. A graph shows the sequence of the steps which must be completed during a comparative test.

15. Relishing his power, Mace ruled that the entire test sequence should be done again.

16. The test sequence is programmed to begin using a digital line from the component handler that serves as a "start of test" (SOT) signal.

17. Figure 4 exemplarily illustrates the sequence of steady state measurement setpoints to be followed for the test.

18. The fixed frequency vibration test proposed to be included in the test sequence is effective in discriminating between acceptable and unacceptable designs

19. Since there are 128 sequence numbers the test program should cycle through this number of information frame transfers.

20. (c) The fixed frequency vibration test proposed to be included in the test sequence is effective in discriminating between acceptable and unacceptable designs;

21. Exhaust gas dilution system flow shall be switched on at least 10 minutes before a test sequence;

22. (h) Exhaust dilution system flow shall be switched on at least 10 minutes before a test sequence;

23. The following sequence shall be followed in dynamometer operation on the test engine, as shown in Figure 3.

24. Sequence data derived from the large IGS resolved the strains into coherent groups; however, the sequence information would not allow any phylogenetic conclusion, because it failed to reflect the accepted species structure of the test strains.

25. Clonality (ID) Test Specimen Requirements The clonoSEQ® Clonality (ID) Test determines the clonal diversity of a sample and can also be used to identify the trackable immune receptor sequence(s) of a lymphoid clone