plastic deformation rate in Vietnamese

@Chuyên ngành kỹ thuật
@Lĩnh vực: xây dựng
-tốc độ biến dạng dẻo

Sentence patterns related to "plastic deformation rate"

1. Under excessive tensile strain, the tubes will undergo plastic deformation, which means the deformation is permanent.

2. Accumulative roll bonding (ARB) is a severe plastic deformation (SPD) process

3. In the 1930s, his research was supplemented with works on the theory of plastic deformation.

4. Ductility is a measure of the degree of plastic deformation that has been sustained at fracture.

5. 22 Powder metallurgical material is compressible in plastic deformation . Its plasticity method needs to be further researched.

6. Fine Blanking makes use of additional supporting tools (pads) and impingement technology to minimize plastic deformation during the shearing

7. Sheet metal Bending is the plastic deformation of the work over an axis, creating a change in the part's geometry

8. The fibrils, which have been torn away from the fibre bundles, show signs of considerable plastic deformation especially in Alkalised …

9. Finally, researchers studied amorphous carbon, a coating material with superior wear resistance, to understand plastic deformation at asperity–asperity junctions.

10. Alternate and more probable estimates of the actual deformation rate levels yield ratios as great as 29,000.

11. In physics and materials science, plAsticity, also known as plastic deformation, is the ability of a solid material to undergo permanent deformation, a non-reversible change of shape in response to applied forces

12. Accumulative roll bonding is a relatively new severe plastic deformation (SPD) process, which was originally introduced and developed by Saito et al

13. Additionally, the grains of sand are bonded together with the elastic or flexible urethane acrylate resin, likewise reducing plastic deformation and cracking.

14. When abrasive grains impacted on the work piece surface, the top layer atomics are removed, plastic deformation appears at the same time.

15. Burnishing may refer to: Burnishing (metal), plastic deformation of a surface due to sliding contact with another object Burnishing (pottery), pottery polishing treatment

16. The deformation rate amplitude, however, affects the absolute value of the complex viscosity and the apparent viscosity in different ways.

17. The effects of the dwell time, strain rate, strain amplitude and their histories on the cyclic deformation behavior are investigated.

18. Brittleness is defined as the tendency of solid material to undergo negligible plastic deformation before fracture when it is subjected to external tensile loading

19. 23 The more the increase of cooling rate or pre-deformation, the more the secondary dendrite arms are easy to coarsen.

20. 27 The more the increasing of cooling rate or pre-deformation, the more the secondary dendrite arms are easy to coarsen.

21. Modelling of deformation behaviour.

22. On base of analysis to simulation result, it was point out the main cause making dissimilar metal"s bonding so difficult was metal"s inharmonic plastic deformation.

23. The dependence of the absolute value of the complex viscosity on the deformation rate amplitude, in the range of large amplitudes, is symbatic to the dependence of the apparent viscosity on the shear rate.

24. On the nanoscale the primary plastic deformation in simple face centered cubic metals is reversible, as long as there is no material transport in form of cross-glide.

Ở cấp độ nano các biến dạng dẻo chính trong kim loại mạng lập phương tâm diện (fcc) là có thể đảo ngược, chừng nào không có sự vận chuyển vật liệu dưới dạng trượt ngang.

25. There is a tendency to underestimate the amount of plastic deformation of the capsule and alternative injuries, such as avulsion of the capsule from the humeral head (HAGL lesion).