modulus of elasticity in Vietnamese

@Chuyên ngành kỹ thuật
@Lĩnh vực: giao thông & vận tải
-môđun đàn hồi E
@Chuyên ngành kỹ thuật
-môđun đàn hồi
-môđun đàn hồi khối
-môđun Young
@Lĩnh vực: điện lạnh
-suất đàn hồi

Sentence patterns related to "modulus of elasticity"

1. The modulus of elasticity depends on the Beam's material.

2. Modulus of ElAsticity - is a measure of stiffness of an elastic material

3. Modulus of ElAsticity of Wood, Wood Engineering Design Data and Elastic ratios.

4. In the formula as mentioned above, “E” is termed as Modulus of ElAsticity

5. The bending modulus of elasticity and flexural strength are very important in this connection.

6. We can write the expression for Modulus of ElAsticity using the above equation as, E = (F*L) / (A * δL) So we can define modulus of ElAsticity as the ratio of normal stress to longitudinal strain.

7. Tensile strength, elongation at fracture and modulus of elasticity according to # in the direction of stresses

8. Tensile strength, elongation at fracture and modulus of elasticity according to EN 61:1977 in the direction of stresses.

9. - Tensile strength, elongation at fracture and modulus of elasticity according to EN 61:1977 in the direction of stresses.

10. - tensile strength, elongation at fracture and modulus of elasticity according to EN 61:1977 in the direction of stresses.

11. Tensile strength, elongation at fracture and modulus of elasticity according to EN ISO 527-5:1997 in the direction of stresses.

12. We can define the stiffness of the Beam by multiplying the Beam's modulus of elasticity, E, by its moment of inertia, I

13. In recent years, acoustic technology has been considered as a potential technology for sorting saw logs into classes of modulus of elasticity.

14. The strength properties of dam concrete, such as compressive and tensile strengths and modulus of elasticity, clearly show rising levels along with increasing concrete age.

15. Flakeboards were tested for internal bond strength, thickness swell, modulus of elasticity, modulus of rupture, and breaking strength in bending, after two severe accelerated aging tests.

16. Several mixes of laterite aggregate concrete were made with varying watercement and aggregate-cement ratios to study the properties like workability, compressive, flexural, tensile strength and Modulus of elasticity.

17. Although 300 freeze–thaw cycles have relatively little effect on standard concrete (without air entrainment), results show that the basic property most affected by slow freeze–thaw cycles is compressive strength and not modulus of elasticity.

18. Acetal Plastic - Sheet, Rod, Tube and Accessories Acetal (Polyoxymethylene or POM) provided by Interstate Plastics is a tough, machinable thermoplastic with a high modulus of elasticity, high strength, good rigidity, dimensional stability, and resistance to moisture, chemicals and solvents.

19. Usually, when we are talking about Compressibility we can say that it is the inverse or reciprocal of the bulk modulus of elasticity. So if look at the unit of Compressibility we are basically considering those of reciprocal pressure, Pa -1 or atm -1

20. Test data is obtained, and from a complete load-deformation curve it is possible to compute the Compressive stress at any load (such as Compressive stress at proportional-limit load or Compressive strength at maximum load) and to compute the effective modulus of elasticity.

21. Match the physical and mechanical properties of the repair concrete as closely as possible with the existing, including: - modulus of elasticity (ASTM C469-02); - cement to aggregate ratio; - aggregate gradation (ASTM C136-05); - compressive and shear strength (ASTM C39/C39M-04a); and, - coefficient of thermal expansion.

22. Described are tape-type magnetic recording media (I) including a non-magnetic substrate (III), at least one film applied to the substrate and, in at least one of these films, an inorganic acicular pigment (II) suitable for use as a supporting pigment, the ratio of the mean length to the mean diameter of the pigment (II) being at least 3 and the mean modulus of elasticity of the films being not less than 15 GPa in the longitudinal direction of the tape-type recording medium (I).