energy loss in Vietnamese

@Chuyên ngành kỹ thuật
@Lĩnh vực: điện lạnh
-độ hao năng lượng
-độ tiêu tán năng lượng
-sự hao năng lượng
-sự tiêu tán năng lượng
@Lĩnh vực: toán & tin
-hao mất năng lượng
-sự mất năng lượng
@Lĩnh vực: xây dựng
-sự tổn hao năng lượng
@Lĩnh vực: điện
-tổn thất điện năng
@Lĩnh vực: điện tử & viễn thông
-tổn thất năng lượng
@Chuyên ngành kỹ thuật
@Lĩnh vực: điện lạnh
-độ hao năng lượng
-độ tiêu tán năng lượng
-sự hao năng lượng
-sự tiêu tán năng lượng
@Lĩnh vực: toán & tin
-hao mất năng lượng
-sự mất năng lượng
@Lĩnh vực: xây dựng
-sự tổn hao năng lượng
@Lĩnh vực: điện
-tổn thất điện năng
@Lĩnh vực: điện tử & viễn thông
-tổn thất năng lượng

Sentence patterns related to "energy loss"

1. 7.1.3 Comparison of Bremsstrahlung and Collisional Energy Loss The question now arises of the relative importance of Bremsstrahlung in calculating the energy loss of an energetic particle in matter

2. Rydberg, electron energy loss, UV absorption, UV photoelectron spectroscopy, alkene, gas-phase.

3. Seismic Attenuation describes the energy loss experienced by seismic waves as they propagate

4. This effect is associated with mechanisms of rapid energy loss involving optical and acoustical phonons.

5. 24 In terms of the effective damping matrix, the energy loss and specific damping of the laminate.

6. Otherwise, we may experience energy loss or become nervous and find even normal activity to be difficult and unpleasant.

7. Investigation of acoustic eigenmodes leads to an algebraic relation between Bathymetrically induced rates of horizontal ray turning and modal energy loss

8. The adverse slope of the inclined steps increases the energy loss ratio and decreases the outlet velocity by less than 10%.

9. Backscattering Spectrometry reviews developments in Backscattering spectrometry and covers topics ranging from instrumentation and experimental techniques to beam parameters and energy loss measurements

10. It also uses roller bearings to cut down on friction and good insulation to keep energy loss and heat-up time to a minimum.

11. When the edge number of characteristic geometry tends towards infinitude, movement of scroll compressor tends to be steadiest and vibration and energy loss decrease least.

12. The energy loss per cycle was found to increase according to the square of the strain amplification factor as expressed by the Guth-Gold-Einstein equation.

13. Expressions are derived for the total energy loss and photon-production spectrum by the processes of Compton scattering, Bremsstrahlung, and synchrotron radiation from highly relativistic electrons

14. 22 For coordination functions of DCF, EDCA, PCF and HCF, the thesis proposes corresponding methods to reduce overhear,(www.Sentencedict.com) which is the greatest source of energy loss for 8011PSM.

15. Earlier computations indicated that a nondisruptive mass loss would be possible in some cases, but later star modeling taking neutrino energy loss into account indicates no such mass loss.

16. Several cytochemical procedures at the light and electron microscope level including enzyme–gold affinity labeling and elemental mapping by electron energy loss spectroscopy were applied to gain detailed information about its fine structure.

17. Tidal effects should Circularize the orbit of a massive planet that's so close to its star; the energy loss that occurs when tides are raised tends to make eccentric orbits round. The planet of 51 Pegasi

18. The vascular optimality principle (VOP) decrees that minimal energy loss across Bifurcations requires optimal caliber control between radii of parent (r₀) and daughter branches (r1 and r2): r₀(n)=r₁(n)+r₂(n), with n approximating three …

19. ‘Go back to the Bremsstrahlung spectrum and see how it fades gradually to zero for long wavelengths.’ ‘The restricted energy loss for muon Bremsstrahlung with relative transfers can be calculated as follows.’ ‘The energy radiated as Bremsstrahlung is typically 100000 times smaller than the energy lost to the plasma electrons.’

20. ‘Go back to the Bremsstrahlung spectrum and see how it fades gradually to zero for long wavelengths.’ ‘The restricted energy loss for muon Bremsstrahlung with relative transfers can be calculated as follows.’ ‘The energy radiated as Bremsstrahlung is typically 100000 times smaller than the energy lost to the plasma electrons.’

21. The present invention relates to a system for injection molding, more particularly to an injection system capable of reducing the loss of resin and improving the molding quality, by providing adiabatic means to joint regions between a molten resin distribution means and an external mold and between a nozzle and a mold, respectively, such that the energy loss due to frequent reheating of the distribution means and the nozzles and the denaturation of the molten resin due to reheating can be avoided to improve the molding quality.