concrete test samples in Vietnamese
@Chuyên ngành kỹ thuật
@Lĩnh vực: xây dựng
-mẫu thí nghiệm bê tông
Sentence patterns related to "concrete test samples"
1. Three test samples shall be taken from adjacent positions from each test section.
2. Three test samples shall be taken from adjacent positions from each test section
3. Key words : lateral load test, piles, reinforced concrete, concrete-filled pipe, seismic, liquefaction, pile curvature.
4. In addition standard samples are provided as reference during the test.
5. Key words : concrete, fissure, injection, water test, pressure, acoustical emission.
6. From Cambridge English Corpus Clotted blood samples were taken from test and …
7. The point Biserial correlation is very similar to the independent samples t-test
8. Key words: alkali-aggregate reaction, British Columbia, concrete, aggregate, expansion test.
9. From the Cambridge English Corpus Clotted blood samples were taken from test and …
10. Test results on additional food samples expected next week will advance the investigation further.
11. Use only columns with response factors close to # for the analysis of test samples
12. Laboratory expansion test results on concrete specimens are sensitive to alkali levels.
13. Test samples giving absorbance values lower than the cut-off are regarded as negative.
14. Result of alkali-silica reaction length change occurs on the concrete samples that used in construction industry.
15. Test samples giving absorbance values lower than the cut-off are regarded as negative
16. However, for initial screening alternative validated assays may be used to test poultry samples.
17. Please note that the samples shown use a test network, ad slot and targeting configurations.
18. The test is a modification of the cobalt thiocyanate test currently used for cocaine and involves Basifying samples rather than acidifying them
19. Use only columns with response factors close to 1 for the analysis of test samples.
20. Samples for the flexibility test shall be prepared in accordance with the ASTM D522 standard.
21. A reference standard cloth was compared with samples that had undergone an alkali solubility test.
22. The belt adjusting device operating test shall be conducted on one of these two samples.
23. Test samples giving absorbance values greater than the cut-off + 0,15 are regarded as positive.
24. — Use only columns with response factors close to 1 for the analysis of test samples.
25. The paired samples T-test performed included # pairs of cumulative standardized abnormal return data for # and