compressive strength at 28 days age in Vietnamese

@Chuyên ngành kỹ thuật
@Lĩnh vực: xây dựng
-cường độ chịu nén trong khi được 28 ngày

Sentence patterns related to "compressive strength at 28 days age"

1. Compressive Strength Testing of Plastics

2. Although the compressive strength gains were accelerated in mixes containing either the proprietary accelerating admixture or CaCl2, the tensile strengths at 28 days were similar for mixes with and without the admixtures.

3. Both 28 and 90 days' age applied at the start of the testing.

4. This allows unexpected quick setting and increased early-age compressive strength without shrinkage in the cement board compositions.

5. Fast setting portland cement compositions with alkali metal citrates and phosphates with high early-age compressive strength and reduced shrinkage

6. However, most of the set accelerators, except for alkali-free accelerators, failed to satisfy the specification because of greater than 40% compressive strength loss at 28 d.

7. Blackcap Admix Contractor Strength provides increased strength, resiliency and compressive and tensile PSI

8. Compressive strength is the maximum load at which the specimen breaks is taken as a Compressive load represented by F or S, which is equal to ratio of Compressive load to cross sectional area of specimen,such as F=P/A, where F = Compressive strength,P = Compressive load and A = area of cross section of specimen.

9. Laboratory testing included sieve analyses and unconfined compressive strength testing.

10. Autogenous deformations, internal relative humidity and compressive strength were recorded.

11. Therefore, knowing the Compressive strength is uttermost important for the designer.

12. Abrasion resistance has close proximity to the compressive strength of concrete

13. Test data is obtained, and from a complete load-deformation curve it is possible to compute the Compressive stress at any load (such as Compressive stress at proportional-limit load or Compressive strength at maximum load) and to compute the effective modulus of elasticity.

14. The strength properties of dam concrete, such as compressive and tensile strengths and modulus of elasticity, clearly show rising levels along with increasing concrete age.

15. Compressive strength is the parameter that represents the concrete in the structural design

16. CONCLUSIONThe Compressive strength of all the three mixes, that is M20, M25 and M30, increases with the addition of glass fibers as compared to Compressive strength of conventional concrete

17. Compressive Strength Properties Perpendicular to the Grain of Larch Cross-laminated Timber

18. You are probably not talking about the Compressive strength of a single particle, rather you are probably interested in the Compressive …

19. The clay mineral has a flexural strength of at least about 200 kilograms per square centimeter and a compressive strength of at least about 2,000 kilograms per square centimeter.

20. The hardness of Anorthosite is 5-6 whereas its compressive strength is Not Available

21. The hardness of Arkose is 6-7 whereas its compressive strength is Not Available

22. Compressive strength test results of field-removed masonry units and assemblies are expected to vary from, and will likely be less than, Compressive strength test results of new masonry units and newly assembled prisms

23. ● Bone has been described as “an engineering masterpiece of tensile, compressive and elastic strength.”

● Xương được miêu tả là “một tuyệt tác kỹ thuật về độ bền, sức chịu nén và sức đàn hồi”.

24. Compressive strength of concrete is a destructive strength, and there is no direct relationship between measured values based on Young’s modulus

25. Workability and strength to cement ratio were increased compared to one or more preexisting concrete compositions having the same 28-day design compressive strength and similar slump by optimizing the ratio of fine aggregate to coarse aggregate.