bending moment in Hungarian

hajlítónyomaték

Sentence patterns related to "bending moment"

1. Check of interference fit strained by additional radial force with bending moment.

2. Plastic hinge characteristic curves are a bending moment (M) — rotational angle (φ) relationship.

3. Bending results from a couple, or a Bending moment M, that is applied

4. Points 4.5.1. (Strength test), 4.5.2. (Resistance to buckling) and 4.5.3. (Resistance to bending moment) only.

5. Performance limits for the tibia bending moment, the criteria ACL and MCL were presented to participants.

6. Moreover, the influence of initial crookedness would be reduced as slenderness ratio and bending moment are increased.

7. The spanwise aerodynamic loading of wings having minimum induced drag is derived for prescribed lift and root-bending moment.

8. A Biaxial column is a column that is subjected to compressive axial force and bending moment in the two planes

9. The shear force and bending moment is initially calculated to determine the point where the Curtailment has to be done

10. Purpose: Critical bending moment (CBM), defined as the bending moment at which the external nonaxial load applied overcomes screw joint preload and causes loss of contact between the mating surfaces of the implant screw joint components, was measured for four different implants and their single-tooth replacement abutments.

11. This force is necessary to create a bending moment that would be able to equilibrate the thermally induced moment due to the dissimilar adherends.

12. The bending moment at this section = Pcr.y The differential equation governing the small Buckling deformation is given by P y dx d y EI cr

13. The curves bending moment vs curvature change are given and discussed for various parameters (ratio of axes A/B, normal pressure q, curvature parameter μ).

14. When the flexible lower legform impactor is used for a test according to paragraph 1.3.3, the absolute value of the maximum bending moment of the tibia at:

15. When the flexible lower legform impactor is used for the test according to paragraph 1.4.3 of this Annex, the absolute value of the maximum bending moment of the tibia:

16. Motorcycle disk brake is widely used because of its small radial dimensions, axial application of force along the disk when braking, no bending moment on brake shaft and braking stability.

17. In this study the influence of sheet pile wall geometry, type of water pressure distribution, and different methods of analysis on the maximum bending moment and achor rod force are presented.

18. In addition, the manufacturer may nominate bumper test widths up to a maximum of 264 mm in total where the absolute value of the tibia bending moment shall not exceed 380 Nm.

19. [In addition, the manufacturer may nominate bumper test widths up to a maximum of 264 mm in total where the absolute value of the tibia bending moment shall not exceed [380 Nm].

20. The concept of substitutive concentrated elastic-plastic rotations, replacing actual elasticplastic zones is used, together with an iterative method of determination of the bending moment distribution to simplify the evaluation of elastic-plastic deflections of hyperstatic beams and frames.

21. Battened member divided equally between parallel planes of the battens. Battened member carrying calculated bending moment due to eccentricity of axial loading, calculated end moments or lateral loads parallel to the plane of battens, shall be designed to carry actual shear in addition to the above shear.

22. Abeam length containing two 50-cm long overlapping splices under constant bending moment is experimentally investigated with the following objectives: examine flexural and splitting crack openings along the splice length; determine the splice strength; study the effective stiffness of the beam length containing the splice, especially during the cracked stage.