kwh in English
Use "kwh" in a sentence
1. Electricity kWh/ADT
2. Fuel kWh/ADT
3. Fuel kWh/ADt
4. Electricity kWh/ADt
5. actual cycle work [kWh]
6. Wact = actual cycle work [kWh]
7. COP (Coefficient of Performance) of the cooling equipment installed (kWh cooling energy produced/kWh energy used)
8. is the average specific emission from a test in which the regeneration occurs [g/kWh or #/kWh]’;
9. VW says the ID.Buzz Cargo's battery capacity starts at 48 kWh and can be increased to 110 kWh
10. (b) additional internal storage: 25 kWh/year;
11. Annual energy consumption (AE) [kWh/yr]
12. 21 A study by MIT put the cost of nuclear electricity at 7 cents per kWh, against 2 cents per kWh for pulverised coal.
13. Wact = actual cycle work as determined in Section 3.9.2, kWh
14. The facility is expected to generate 527,702 kWh of power annually.
15. is the hydraulic accumulator (maximum) energy capacity, kWh
16. is the actual cycle work of the hot start test, kWh
17. actual cycle work, as determined in Annex III Section 4.6.2 (kWh)’.
18. is the actual cycle work on the cold start test, kWh
19. Wact = actual cycle work as determined in paragraph 3.9.2., kWh.
20. W act = actual cycle work as determined according to section 3.9.2, kWh.
21. Wact,hot is the actual cycle work on the hot start test, kWh
22. The specific emission (g/kWh) shall be calculated for all individual components:
23. Wact = actual cycle work as determined in Annex III Section 4.6.2, kWh
24. is the actual cycle work of the hot start NRTC (kWh)
25. is the actual cycle work of the hot start NRTC (kWh).
26. is the actual cycle work as determined according to paragraph 7.8.6., kWh
27. The Maximum TEC (ETEC_MAX) in kWh for Monitors shall be calculated as per Table 1.
28. On a per-kWh basis, wind is subsidized 50 times as much as traditional sources.
29. actual cycle work over the cold start cycle as determined in Annex III section 4.6.2 (kWh)
30. W act, hot is the actual cycle work of the hot start NRTC (kWh)
31. weighted specific fuel consumption (g/kWh) calculated according to the formula as below
32. The emissions (g/kWh) shall be calculated for all individual components in the following way:
33. The kWh is charged € 0,06 during low price hours and 0,10 Euro during peak hours.
34. · Reduction of 10% in absolute demand for electricity by industry, from the current level of 42.1 billion kWh (excluding electricity used to meet the needs of electric power plants themselves, of 6 billion kWh);
35. — cair is the specific heat capacity of air at constant pressure and density [kWh/(m3 K)];
36. actual cycle work over the hot start cycle as determined in section 4.6.2. of Annex III, (kWh)
37. actual cycle work over the hot start cycle as determined in paragraph 4.6.2. of Annex 4A, (kWh)
38. actual cycle work over the cold start cycle as determined in section 4.6.2. of Annex III (kWh)
39. actual cycle work over the hot start cycle as determined in section 4.6.2. of Annex III. (kWh)
40. actual cycle work over the hot start cycle as determined in section 4.6.2. of Annex III, (kWh)’
41. actual cycle work over the hot start cycle as determined in section 4.6.2 of Annex III, (kWh)
42. Based on the national average of 12.6 cents/kwh, fully Charging an all-electric vehicle with a 100 mile range and
43. The most important key figure in this context is kilowatt-hours per square meter per year (kWh/m2a).
44. Calculation for paper production: Similarly, the fuel consumption related to paper production (Fpaper, expressed in kWh/ADt) shall be calculated as follows:
45. Between January and July this year , Vietnam produced an estimated 44.9 billion kWh , up 9.6 % from the same period last year .
46. Calculation for board production: Similarly the fuel consumption related to the board production (Fboard, expressed in kWh/ADT), shall be calculated as follows:
47. The city of Brunsville (Iowa) has an average annual solar radiation value of 4.85 kilowatt hours per square meter per day (kWh/m2/day)
48. As few of us are likely to wish to check the Calorific value and volume correction figures independently, and as the conversion from MJ to kWh is a fixed value, would it not be simpler just to quote the Calorific value of the gas supplied as kWh / m³ ? This single figure would then relate the meter reading to the energy charged for.
49. Calculation for pulp production: For each pulp i used, the related electricity consumption (Epulp, i expressed in kWh/ADT) shall be calculated as follows:
50. Calculation for pulp production: For each pulp i used, the related electricity consumption (Epulp, i expressed in kWh/ADT) shall be calculated as follows