1. Digital pulse-width-modulation control of a radio frequency power supply for pulsed laser

2. A discharge tube for a gas laser generator, especially one driven by a high-frequency (including a radio-frequency) AC power supply.

3. Low-power Licence-exempt Radiocommunication Devices (All Frequency Bands): Category I Equipment;

4. 6 Measuring ferromagnetic component volt - ampere characteristic in low frequency condition can offset deficiency of power - frequency experiment.

5. A low noise narrowband amplifier (202) with low power consumption for amplifying radio frequency and microwave signals.

6. For the advantages of resisting laser and low ullage, the ultrathin aluminum film can be applied in high -power laser system .

7. Laser frequency stabilization derived from Cr atomic beam laser induced fluorescence is a good way to solve excursion of laser frequency in Cr atom lithography.

8. LAPQ: High Energy Laser Aplanats High performance air-spaced laser aplanat for UV and high power use; single wavelengths from 266-1064 nm

9. KNbO3 is an inorganic crystal normally used for frequency-doubling low- and medium-power lasers.

10. Detect power supply problems using the Communicator’s power the loop functionality or by monitoring low frequency noise on a segment.

11. Laser pointer, power supply device, laser pointer manufacturing method, and power supply device manufacturing method

12. Low frequency acoustic attenuator

13. Low frequency acoustic microscope

14. Short stubs (16), which interrupt the transmission of a low-frequency signal (SL), are connected to the high-frequency power supply lines (8).

15. Green laser pointer and Red laser pointer built into a single unit.

16. The system also has 128 MB of low power single channel RAM (Mobile DDR).

17. Bonded channel configurations may be adjusted to single channel configurations for low power operation.

18. The result is a small footprint, low profile package that consumes only a few milli- watts of power and requires a single low voltage power supply.

19. Laser acupuncture is a combination of Low Level Laser Therapy (LLLT) and acupuncture.

20. The wireless access link signal (20) comprises low power radio frequency distribution using empty UHF/VHF TV channels.

21. Ultra-low power switching regulator method and apparatus with adaptively adjustable switching frequency and peak current trip point

22. The power transmitted into an acoustic fluid by a finite flat plate vibrating with low frequency is investigated.

23. Laser frequency stability equal to or better (less) than 10 MHz;

24. The frequency was calibrated using an acousto-optic modulator to frequency shift part of the laser beam.

25. Modular laser alignment device for power tool

26. Ac/dc power converters having low power consumption or low power loss

27. "Laser" frequency stability equal to or better (less) than 10 MHz;

28. Low-cost Cartridges for inkjet and laser printers

29. Single polarisation, single pulse mode lock laser generating device capable of energy adjustment

30. The system includes within the optical cavity an active laser medium (LM), a second harmonic generator for generating second harmonic frequency of the fundamental frequency emitted by the laser.

31. Brawn is an excellent introduction to low volume, low frequency workouts

32. Specially designed for laser-beam manipulation and focusing at low to moderate power, these Achromats are computer optimized for infinite conjugate ratio

33. Covered except for AC mains frequency variations and power frequency magnetic fields

34. The Corvus replaces the Vela's Meltdown -like laser with a long-range, single-shot piercing laser

35. A laser diode with a low absorption diode junction

36. The low-power frequency divider generates a frequency-divided signal with frequency equal to the frequency of the input signal divided by a fixed ratio, and is equipped with a phase-voltage converter, a comparator, a phase-locked loop and a reset circuit.

37. There is provided a high power laser drilling system utilizing an electric motor laser bottom hole assembly having the high power laser beam traveling within the electric motor for advancing a borehole.

38. Power supply system frequency (e.g. AC, DC

39. It's a low-frequency, acoustic RF buffer transmitter.

40. Low-pass filter of graphical tablet has cut-off frequency lower than sampling frequency

41. A filter used for Blurring is also called low pass filter, because it allows low frequency to enter and stop high frequency

42. Compliance testing of low frequency demand disconnection relays

43. A low-pass filter (110) has a cut-off frequency lower than the shift frequency.

44. Brushless high-frequency alternator and excitation method for three-phase ac power-frequency generation

45. The maximum radio-frequency power transmitted for Pixel:

46. The total Attenuation at a single frequency scales with length, so to double the length is to double the loss at a single frequency

47. LOW FREQUENCY LONG RANGE RADIO NAVIGATION AIDS (L.F. LORAN)

48. The low frequency process has a concentration indépendant relaxation frequency and an absorption proportional to concentrationc.

49. IEPE Triaxial Accelerometer, Center Through Hole, Ceramic Shear, 50 … 2000g Type 8764B MEMS Capacitive Single Axis Accelerometer for Low Frequency Applications, K-Beam, 2… 200g

50. Frequency), Aliasing is a false translation of power falling in some frequency range outside the range

51. Specifically, data suggests that Tyrannosaurus rex heard best in the low-frequency range, and that low-frequency sounds were an important part of tyrannosaur behavior.

52. Laser-ablation-based material analysis system with a power/energy detector

53. Ac load soft start for variable frequency power source

54. The maximum radio-frequency power transmitted for Pixel XL:

55. A series hybrid active power filter for aeronautical variety - frequency power grid is studied.

56. Sensor and method for detecting very low frequency acoustic signals

57. Yttrium Aluminum Garnet laser ceramics is an ideal material substitute for Yttrium Aluminum Garnet laser single crystal because of its excellent properties.

58. High-frequency coupler or power splitter, especially a narrow-band 3db coupler or power splitter

59. tunable pulsed single-mode dye laser oscillators having all of the following characteristics:

60. The amplitude modulation signal is separately dealt with in a low-frequency portion and a high-frequency portion.

61. Airgun array (36 guns) used for seismic testing (low frequency) 180 to 200 (total sound of array) Single airgun for seismic testing (low frequency) 234 Tug and barge (18 km/hour) 171 Mid frequency military sonar 235 Large Tanker 186 Loud sounds can physically harm a porpoise, but even lower levels of sound can disrupt their lives.

62. Low power rfid reader that gives visibility to passive tags as active tags using low power 802.11

63. Some SLS machines use single-component powder, such as direct metal laser sintering.

64. This one is very low-power.

65. The Applied Biosystems Arcturus LCM System offers the power of two lasers—combining laser-capture and laser cutting into one system

66. The MX-118B consists of a heavy duty custom 18" low frequency driver in a sturdy and portable bandpass enclosure optimally tuned for extended low frequency response."

67. Method of adjusting timing transmission parameters in a single frequency network

68. Circular and elliptical polarization of a high power laser by adjoint feedback

69. The Death Star's laser power works in a similar method to this by concentrating multiple light beams into one spot from where they combine into a single beam.

70. Said alternating power network operates at a specified frequency and a frequency range is defined around the specified frequency and the control power which must be provided in the event of a frequency deviation within the frequency range is provided by an energy accumulator up to more than 50%, with respect to the total control power to be provided.

71. Single-screen multi-frequency synchronized 2d and 3d audio-visual system

72. Described herein are systems and methods for the reduction of power consumption and mitigation of device stress accumulation in low frequency refreshed Liquid Crystal Displays (LCDs).

73. The laser beam is directed in the X and Y directions with two high frequency scanning mirrors.

74. Method and apparatus for high frequency alternating current power distribution

75. Bist method for testing cut-off frequency of low-pass filters

76. The scanner emits a low frequency radio signal, activating the microchip.

77. Applying an AC bias to the emitter, such that the frequency is synchronised with the irradiation frequency, preferably at half the frequency of the irradiation frequency of the excitation laser, serves to reverse the effects of space charge polarisation.

78. 1,2Finally, by strategically choosing three pointson the K-spectrum and tuning the laser Alternatelyto each of them, temperature and line-of-sightwind speeds in the mesosphere can be measured.This frequency switching is done by locking theseed laser, then frequency modulating the

79. A laser-ablation ion source is provided for generating a low energy ion beam having low longitudinal and transverse emittance.

80. A feedback circuit having a low cut-off frequency (F¿1?